VkCommandBufferUsageFlagBits(3)
C Specification
Bits which can be set in VkCommandBufferBeginInfo::flags,
specifying usage behavior for a command buffer, are:
// Provided by VK_VERSION_1_0
typedef enum VkCommandBufferUsageFlagBits {
VK_COMMAND_BUFFER_USAGE_ONE_TIME_SUBMIT_BIT = 0x00000001,
VK_COMMAND_BUFFER_USAGE_RENDER_PASS_CONTINUE_BIT = 0x00000002,
VK_COMMAND_BUFFER_USAGE_SIMULTANEOUS_USE_BIT = 0x00000004,
} VkCommandBufferUsageFlagBits;Description
-
VK_COMMAND_BUFFER_USAGE_ONE_TIME_SUBMIT_BIT specifies that each recording of the command buffer will only be submitted once, and the command buffer will be reset and recorded again between each submission.
-
VK_COMMAND_BUFFER_USAGE_RENDER_PASS_CONTINUE_BIT specifies that a secondary command buffer is considered to be entirely inside a render pass. If this is a primary command buffer, then this bit is ignored.
-
VK_COMMAND_BUFFER_USAGE_SIMULTANEOUS_USE_BIT specifies that a command buffer can be resubmitted to any queue of the same queue family while it is in the pending state, and recorded into multiple primary command buffers.
Document Notes
For more information, see the Vulkan Specification.
This page is extracted from the Vulkan Specification. Fixes and changes should be made to the Specification, not directly.